This installation is not required, but it will offer some improvements if you are experiencing wireless connection issues.
TECH MANUAL DOWNLOADS
| PROBLEMS | CORRECTIVE ACTION |
| . No power. . No flash on the monitor screen. . No cooling fans operating. |
. Check that the power cord is connected to a "live" outlet. . Check that the power switch is on. |
| . Poor picture quality. | . Adjust Brightness, Contrast, Horizontal and Vertical control with the monitor controls located on the OSD board. |
| . Game locks up or resets while being played or in the attract mode. . No movement on the screen. . Power has to be cycled off and on to get the game to function again. |
. Clean the vents and the fans of any dust and dirt that may interfere with airflow. . Perform a checksum test on the hard drive: . Turn off the game. . Press and hold the SETUP button while turning on the game. . The diagnostic page will appear. Touch the option for DIP switch 8. The test will take about 10 minutes. . A failure will cause the test to stop. . A passed test will display" DRIVE CHECKSUM COMPLETE. RESET ALL DIP SWITCHES TO REBOOT MACHINE". • Clear memory with the following procedure: • Turn off the game. • Press and hold the “setup” and “Calibrate” buttons. • Turn the game on and keep holding the buttons until the screen displays” TWO BUTTON CLEAR DETECTED RELEASE BUTTONS”. This should take about 30 seconds. • Release the buttons. This will clear high scores, clear the books and reset options, and reset the game menu and coin menu to their factory settings |
| . "ERROR READING DRIVE C" | . This message can be caused by the hard drive. Perform a checksum test on the hard drive: . Turn off the game. . Press and hold the SETUP button while turning on the game. . The diagnostic page will appear. Touch the option for DIP switch 8. The test will take about 10 minutes. . A failure will cause the test to stop. When the hard drive fails the test, the game will lock up with a "CHECKSUM ERROR" message, which will stay on the screen until the power is turned off. In this case, the hard drive will have to be replaced. A passed test will display "DRIVE CHECKSUM COMPLETE. RESET ALL DIP SWITCHES TO REBOOT MACHINE". |
